9
8
1Care
1-1Theproductcanbefoldedforstorage.Operationmethod:pull
outwardandholdtheadjustingknob,rotatethemovablesupportuntil
it is perpendicular to the ground; release the finger holding the
adjustingknob,swingthemovablesupportbackandforthslightly;the
internalgearsoftheadjustingknobwillbeinplacewithaclickwhile
checking that the gear at the adjusting knob is not exposed, then the
movablesupportiscompletelylocked.
Attention:theanglewherethemovablesupportisperpendicular
tothegroundisalimitingposition.Ifthemovablesupportisbehindthe
limitingposition,itiseasytocausethebiketrainertotopplebecauseof
instability,resultinginaccidentalinjuryandpropertyloss.
1-2 The product shall be stored in a clean and dry indoor
environment, avoiding direct sunlight, away from fire and water
sources,orotherdangerousgoods.
1-3Whencleaningthisproduct,justwipeitwithacleancloth.Do
notusedetergent,cleaningpowder,orotherchemicalsolventstoclean
itsoasnottodamagethepaintonthesurfaceofthebiketrainer.
2Maintenance
2-1PulleyTensioningAdjustment
The manufacturer has adjusted the pulley tension when the
productleavesthefactory. Afterusingtheproductforsometime,the
pulleytensionwillbeinsufficient,causingittoslip(it'sperformance:
whensteppingonthepedal,thepersonmayfeeldifferentstrength).At
this time, it is necessary to adjust the pulley tension. The specific
CareandMaintenance
methodsareasfollows:
1)AsshowninFigure9,insertthehexagonwrenchCRV-5(bigger
one)intothesideadjustinghole,gentlyrotatethewrenchsothatthe
wrench is fully matched with the inner hexagonal hole of the internal
screw. Turn the wrench half-circle counterclockwise until the internal
screwisloose.
2)AsshowninFigure9,insertthehexagonwrenchCRV-4(smaller
one)intotheupperadjustinghole,gentlyrotatethewrenchsothatthe
wrench is fully matched with the inner hexagonal hole of the internal
screw.Turnthewrenchhalf-circleclockwiseuntiltheinternalscrewis
loose.
3) Turn the hexagon wrench CRV-5 (bigger one) half-circle clockwise
until the internal screw is firmly locked.
4) Test: step on the pedal of the bike installed on the bike trainer;
there shall be no feeling of different strength.
2-2 Replace the Batteries of the Power Module or Power Module
After using the product for some time, when pairing with the third-
party riding software, the riding equipment may not be detected even
when rotating the pulley. It is generally because the battery in the power
module of the bike trainer is dead. At this time, the battery in the power
module needs to be replaced. Refer to UNISKY videos for the battery
replacement method. If the riding equipment can not be detected after
battery replacement, the replacement of the whole power module should
be considered.
Tip: Power Module Battery Model CR2032
FAQ
When an exception occurs, please check and resolve it according to
the table below.
Attention:
If the abnormal phenomena are still unavoidable, please contact the
UNISKY authorized distributor for assistance. Do not disassemble this
product by yourself, which may cause product damage and affect after-
sales service!
