If the black cross ap-
pears as shown here,
your mirror is correctly
aligned.
If the black cross appears
as shown here, you need to
realign your mirror.
REPEAT THE PROCEDURE UNTIL THE CROSS IS CENTERED. SEVERAL ATTEMPTS MAY
BE REQUIRED.
Turn the focus wheel to align the visual mark. Orient the telescope toward a target and
enjoy the view.
Scan this QR code
to be redirected to our
video on collimating your telescope.
Use the T20 Torx
wrench (telescope tool
1) in the toolbox.
Use the joystick arrows to move the telescope so that the star is at
the edge of your screen. Which edge depends on your cross. If the
cross is right of center, use the joystick to place the star on the right
edge of the screen; if the cross is left of center, place it on the left
edge, and so on.
Once the star is on the correct side, turn the vertical or horizontal mirror
mount screw with the T20 torx wrench (telescope tool 1) to adjust the
mirror and re-center the star on the screen and eyepiece.
Use caution with the screws. If you are a beginner, take your time and do not
skip any steps.
U
ser
guide
|
17
E
nglish
