17
midnight) or manually. Press the [+] key or [
-
] key to switch between “Clears 24h” and
Clears Manually.
10.
Temperature Units of Measure (default:
°C
):
. Press the
SET(MODE)
key again to
change the temperature units of measure (the
UNITSET
icon will be displayed). Press
the [+] key or [
-
] key to switch between °F and °C units of measure.
11.
Wind Speed Units of Measure (default: m/s)
. Press the
SET(MODE)
key again to
change the wind speed units of measure . Press the [+] key or [
-
] key to toggle the wind
speed units between m/s, km/h, mph, knots or bft.
12.
Rainfall Units of Measure (default: mm)
. Press the
SET(MODE)
key again to
change the Rainfall units of measure. Press[+] key or [
-
] key to toggle the rainfall units
between mm and inch.
13.
Barometric Pressure Display Units(default: hPa)
. Press the
SET(MODE)
key again
to change the pressure units of measure. Press the [+] key or [
-
] key to toggle the
pressure units between mmhg, inHg or hPa.
14.
Pressure Threshold Setting (default level 2).
Press the
SET(MODE)
key again to
change the pressure threshold. Press the [+] key or [
-
] key to change pressure threshold
2 mbar/hour to 4 mbar/hour.(For detailed information of this part please refer to 15.5)
15.
Weather Icons Setting (default: partly cloudy).
Press the
SET(MODE)
key again to
change the initial weather icon. Press the [+] key or [
-
] key to select the initial weather
icon of Sunny, Cloudy, Partly Cloudy or Rainy. (For detailed information of this part
please refer to 15.1 and 15.2)
16.
Sunlight Display Units(default: W/
㎡
)
. Press the
SET(MODE)
key again to change
the sunlight units of measure. Press the [+] key or [
-
] key to toggle the sunlight units
between ,
W/
㎡,
fc
or lux.
8.
Location division.(default: Northern Hemisphere).
Press the
SET(MODE)
key again
to change the location division. Press the [+] key or [
-
] key to toggle the sunlight units
Northern Hemisphere (NOR)or Southern Hemisphere(SOU).
(
refer to 5.0 Final
Installation of Integrated outdoor transmitter
)
7.3 Chanel Selection
Press the
C
button to switch the display between remote thermo-hygrometer
sensors 1 through 8, and scroll mode
. In scroll mode, all of the detected thermo-
hygrometer sensors will be displayed in five second intervals.
7.4
Sensor
Search
Mode
If a sensor loses communication, dashes (--.-) will be displayed. If a specific channel is
lost, press the
CH/+
button to display that channel prior to entering the search mode.
To reacquire the lost signal, press and hold the
CH/+
button for 3 seconds to enter the
sensor search mode.
The icon
AIO
will appear in the time area. You can synchronize one or all of individual
sensors. press the [+] or [-] key to toggle between the following sensors:
•
AIO
. Synchronizes Integrated outdoor transmitter
•
CH*
. Synchronizes Channel 1-8 Sensors (dependent on which channel is displayed
before entering the Sensor Search Mode).
•
ALL
. Synchronizes All Sensors.
•
NOT
. Do nothing and exit the Sensor Search Mode.
