7
DIP SWITCH
FUNCTION
1
2
3
4
DOWN DOWN DOWN ---
Channel
1
DOWN DOWN UP
---
Channel 2
DOWN UP
DOWN
---
Channel 3
DOWN UP
UP
---
Channel 4
UP DOWN
DOWN
---
Channel 5
UP DOWN
UP
---
Channel 6
UP UP DOWN
---
Channel 7
UP UP UP
---
Channel 8
--- --- ---
DOWN °F
--- --- ---
UP
°C
Table 1
4.
Insert two AAA batteries.
5.
After inserting the batteries, the remote sensor LED indicator will light for 4
seconds, and then flash once per 60 seconds thereafter. Each time it flashes, the
sensor is transmitting data.
6.
Verify the correct channel number (CH) and temperature units of measure (°F
vs. °C) are on the display, as shown in Figure 9.
Figure 9
(1) temperature
(2) temperature units (°F vs. °C)
(3)
channel
number
(4)
relative
humidity
7.
Close the battery door. Make sure the gasket (around the battery compartment) is
properly seated in its trace prior to closing the door. Tighten the set screw.
3.4
Display
Console
3.4.1 Display Console Layout
