13. During unit operation, the main burner appearance and
igniter location should be as shown below:
14. With the main burners off, disconnect the manometers and
replace the plugs. Check for gas leakage at the plugs.
15. Replace all access panels.
LABELS
1. Remove label 035-11635-000 from the shipping box.
Check the natural gas to Propane box. If in Canada, check
the appropriate box for respective conversion station.
NOTE: If the unit has been converted from natural gas
to propane (LP), place the new label over the existing
label and fill in the appropriate information.
2. Under "Rating After Conversion", write in the following:
a. Orifice size, as stamped on the orifice
b. Maximum inlet pressure
c. Minimum inlet pressure
d. Manifold pressure for both low and high inputs
e. Input ratings, same as on the Rating Plate
f. Output ratings, same as on the Rating Plate
3. Under "Changes After Conversion", write in the following
a. Kit number, located on the outside of the box
b. Unit model number
c. Other than Canadian, stamp or write in the name of the
organization making conversion, address, city,
state,
month
and
year
4. Remove label backing and affix label adjacent to the
Rating Plate.
5. On propane (LP) conversions, affix the corresponding gas
valve label (provided in the conversion kit) to the valve.
Subject to change without notice. Printed in U.S.A.
Copyright
by Unitary Products Group 1998 All rights reserved.
650.78-N2.1V
5005 York Drive
Norman, OK
73069
Unitary
Products
Group
BLUE CONE PORTION
OF FLAME SHOULD
ENTER HEAT
PROPER BURNER FLAME APPEARANCE
