10
www.csunitec.com
Original instructions VARILEX® 1802 HT
EN
8.
Accessories
Only use original Eisenblätter accessories.
Use only accessories that fulfil the requirements and
specifications listed in these operating instructions.
Cutting disc cover clip / safety cover for cut-off grinding:
Designed for work with cutting disc and diamond cutting discs.
Once the cutting disc cover clip is fitted, the safety cover
becomes a cutting safety cover.
Art. no.
Description
65028
Grinder Grip™ magnetic machine
holder
65041
3D ball handle
65042
Safety cover Ø 125 mm
65043
Safety cover Ø 150 mm
65045
Cutting disc cover clip Ø 125 mm
65046
Cutting disc cover clip Ø 150 mm
65048
Protective suction cover Ø 125 mm
Use abrasive tools made from Eisenblätter for best work
results, such as:
•
Cutting discs and rough grinding discs
•
Flap discs
•
Fibre discs
•
Cleaning discs
•
Backing plates
•
Quick-change systems for discs
Note:
Accessories shown or described are not part of the
standard delivery scope of the product. The complete program
can be found on
www.eisenblaetter.de or in the catalog.
9. Initial operation
9.1 Attaching the additional handle:
Always work with the additional handle (A2-2)
attached! Attach the additional handle on the left or
right of the machine and secure.
9.2 Attach the safety cover:
For safety reasons, always use the safety cover
provided for the respective disc! See also chapter
8. Accessories.
Safety cover for grinding:
Designed for work with rough grinding discs, flap
sanding pads, diamond cutting discs.
See page 3, figures C1, C2 and C3.
•
Push and hold the lever (C1-1). Place the safety cover (C2) in
the position indicated.
•
Release the lever and turn the safety cover until the lever
engages.
•
Push the lever and turn the safety cover until the closed
section is facing the operator (C3).
•
Make sure that the safety cover is placed securely: The lever
must engage and you should not be able to turn the safety
cover.
Use only grinding tools that are
covered by at least 2 mm by the
safety guard.
(Disassemble in reverse order.)
Before commissioning, check that the rated mains
voltage and mains frequency, as stated on the type plate match
your power supply.
Always install an RCD with a maximum trip current of 30
mA upstream.
The red electronics signal indicator (A2-1) lights up briefly
when the mains plug is inserted in the socket, indicating
readiness for operation.
Setting speed:
Set the recommended speed at the thumbwheel (A2-1). (Small
number= small speed; large number = high speed)
1
2,800 min-1
4
6,850 min-1
2
4,150 min-1
5
8,200 min-1
3
5,500 min-1
6
9,600 min-1
Cutting disc, rough grinding disc, cup wheel, diamond cutting
disc: high speed
Brush: medium speed
Sanding plate: low to medium speed
The VTC electronics make material-compatible work possible
and an almost constant speed, even under load.
The best way to determine the ideal speed setting is by
performing a test.
Particulate matter protection cap:
Always fit the particulate matter protection cap
(A1-1) if the surroundings are heavily polluted.
Attachment:
See page 2, figure B1/B2.
Fit the particulate matter protection cap as shown.
To remove:
Slightly lift the particulate matter protection cap at
the upper edges and remove it downwards.
1-800-700-5919 (US/CA)
www.csunitec.com
info@csunitec.com
+1-203-853-9522 (Intl.)
