W A S H
S E L E C T
I I
T O
W A S H P A Y
Document Number:
WS21046
1
Document Name:
WSII to WashPayIntegration Field Retrofit Installation Guide
1 Introduction
This manual provides instructions for integrating the Wash Select II to the WashPay Site
Management System. Perform the steps in this manual to all Wash Select II units, the
POS4000, and the WashPay server.
Before beginning installation, you must also ensure that you have Wash Select II units,
the WashPay server, the router, Internet access through your local Internet Service
Provider, and a CAT5E cable terminated in an RJ45 jack running from the router in the
office/C-store to the Wash Select II. The CAT5E cable should not be more than 250 feet
in length.
2 Retrofit Installation Procedures
2.1 Parts Checklist
Prior to retrofitting the existing Wash Select II units, verify that all parts in the WSII to
WashPay Network Upgrade Kit are present.
•
WSII to WashPay Network Expansion Board
•
Expansion Board Ribbon Cable
•
4 4-40 M/F stand-offs
•
4 4-40 Nuts with Washers
•
Wash Select II EPROM Software Chip version 6.00
•
POS4000 EPROM Software Chip version 8.25 and above
•
This document
3 Hardware Installation Procedures
3.1 Perform System Backup
Prior to upgrading the software, it is highly recommended that you generate a hard copy
of your site-specific information. This will make it much easier to reprogram your system
in the event of data corruption or loss.
