7
.
6
、
Back-up ring
7
、
Seat adjusting unit
8
、
Adjusting screw
5.5.2 According to film width, fix the seat ring on the left of the shaft, and fix the
seat sleeve on the left of the shaft, insert the friction piece, and then put the film
on the shaft.
5.5.3 Put on the second friction piece and gasket, then put the seat adjusting ring;
and close to the gasket. Make the puller screw tightened, and then make adjusting
screw tighten on the gasket. More tightly, more tension of the film, it should be
up to the requirement.
5.5.4 Place the film shaft and film on the installation frame, each part should be
placed in right position as drawing 2 views.
5.6 Use of film cutting knife
5.6.1 This machine adopts round cutting knife and it has been fixed on the tool
carrier, and the tool carrier is fixed on the tool carrier shaft. Use stopper rings to
fix onto the left and right of tool carrier.
5.6.2 Support the tool carrier by hand, pull up the pin of tool carrier, put down the
tool carrier gently, and make the cutting knife piece press on the film.
5.6.3 Adjust the position of tool carrier according to the length of film need
cutting, and then tighten the stopper rings. After this, use gummed tape to stick
the film head, then the film will be cut separately with machine running. And the
1
、
Seat ring
2
、
Installation frame
3
、
Seat ring
4
、
Friction disk
5
、
bolt
6
、
Back-up ring
7
、
Seat adjusting unit
8
、
Adjusting screw
9
、
roller for film
文件使用
"pdfFactory Pro"
试用版本创建
www.fineprint.cn
