14
3-2 Example 1: Single-parameter setting by scanning 1D barcodes
Important notes:
1. After each successful programming, the embedded scanner will beep twice.
2. Throughout the programming barcode menus,
the factory default settings are indicated with
asterisks (*).
Two programming modes have been provided as bellows:
❶
Single-scan setting
Scan the appropriate
Single-scan setting
(e.g.
%0101D00%
) according to the user‘s demand.
Example:
To set Flow control to be XON/XOFF.
Steps:
Scan the following barcode.
❷
Multiple-scan setting
Step 1. Scan the
Option barcode
barcode (e.g.
%0101M%
) according to the user’s demand.
Step 2. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan
two alphanumeric entries from
0
to
9
or
A
to
F
, refer to
11 Configuration alphanumeric entry
Step 3. Repeat Step 2, if more user parameters input are required.
Step 4. Scan the
%END%
barcode, listed on the lower left hand corner of each parameter
setting part.
Example:
To set Flow control to be XON/XOFF.
Steps:
Scan the following barcodes in order.
Summary of Contents for ES922
