Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
54
7.9 Setup Insertion
To setup the insertion of output characters
1. Scan the label of the desired set.
2. Scan the label of the desired symbology.
3. Go to the Decimal Value Tables in Appendix A, scan label(s) that represents the
desired position to be inserted.
4. Scan the “Complete“ label of “Character Position to be Inserted“.
5. Go to the ASCII Tables in Appendix B or Function Key Tables in Appendix C, scan
label(s) that represents the desired characters to be inserted.
6. Scan the “Complete“ label of “Characters to be
Inserted“.
7. Repeat the steps 1 - 6 to set additional insertion.
A Select Insertion Set Number
1st Set
2nd Set
3rd Set
4th Set
5th Set
6th Set
