45
© 2016 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd
4.7 Sensitivity of Continuous Reading
Mode
A. Quick Setting
Fast *
Slow
B. Same Code Delay Reading Interval
Following code sequences represent the length of time before a barcode can
be rescanned at continuous and flash reading mode. The value can be
defined from 1-50 and they represent 100ms to 5 seconds in100ms interval.
Default value is 3 (0.3 seconds).
To setup same code delay reading interval:
1. Scan the "Begin" label
2. Go the Numeric Bar Codes in Appendix A, Scan label(s),that represents
the same code delay reading interval. They are ranged form 1-50.One step
is represented 0.1second.So the interval is from 0.1 to 5 seconds.
3. Scan the "Complete" label
Repeat the steps 1-3 to set time out of same symbol
1. Begin 3. Complete
2. Numeric Bar
Codes (Appendix A)
