2. Insert another dongle into a
USB port of the computer or
laptop PC.
3. Scan the MAC address of
the dongle by using the
MS840B scanner.
4. When being successfully
connected to the dongle, the
scanner will beep shortly one
time with a high tone.
Memory Buffer Setting
The collected data can be sent back to a host computer one by one via the WPAN
connection as the scanner is set to the Batch Mode, or can be stored in the flash
memory of the scanner being set to the Inventory Mode.
By default, the Batch Mode is enabled for use when the scanner is out of range.
Upon reading a barcode successfully within range, the scanner responds with one
short beep (high tone) and its LED indicator becomes solid green and goes off
f
B transmit buffer, the scanner can ignore the
on reading barcodes until the buffer is full.
d and the scanner is out of range, the scanner will
respond with two short beeps, high-low tone, upon reading a barcode successfully.
When the memory buffer is full, the scanner will respond with one long beep (low
tone) and its LED indicator will become solid red and go off quickly. You are
advised to get back to range.
quickly. However, the host computer may not receive the data immediately i
getting out of range. With the 4 K
transmission status and keep
When the Batch Mode is enable
15
Summary of Contents for MS840B
