Chapter 3
Barcode Setup Menu
User Preferences
Set Default Parameter
You can reset the digital scanner to two types of defaults: factory defaults or custom
defaults. Scan the appropriate barcode below to reset the digital scanner to its
default settings and/or set its current settings as custom defaults.
Set Defaults
- Scan this barcode to reset all default parameters. If you previously
set custom defaults by scanning Write to Custom Defaults, scan Set Defaults to
retrieve and restore the digital scanner’s custom default settings.
Write to Custom Defaults
- Scan this barcode to set the current digital scanner
settings as custom defaults.
Parameter Scanning
To disable decoding of parameter barcodes, scan the Scanning barcode below.
Note that the parameter barcode can still be decoded. To enable decoding of
parameter barcodes, either scan Enable Parameter Scanning or Set All Defaults.
37
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Summary of Contents for MS842PG
Page 2: ......