Parity
A parity check bit is the most significant bit of each ASCII coded character. Select
the parity type according to host device requirements.
Select
Odd
parity to set the parity bit value to 0 or 1, based on data, to ensure
that the coded character contains an odd number of 1 bits.
Select
Even
parity to set the parity bit value is set to 0 or 1, based on data, to
ensure that the coded character contains an even number of 1 bits.
Select
None
when no parity bit is required.
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of
transmission of one character and prepares the receiving device for the next
character in the serial data stream. Select the number of stop bits (one or two)
based on the number the receiving terminal is programmed to accommodate. Set
the number of stop bits to match host device requirements.
Data Bits
This parameter allows the digital scanner to interface with devices requiring a 7-bit
or 8-bit ASCII protocol.
23
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Summary of Contents for MS84X-2
Page 2: ......
