Code 39 Full ASCII Conversion
Code 39 Full ASCII is a variant of Code 39 which pairs characters to encode the full
ASCII character set. To enable or disable Code 39 Full ASCII, scan the appropriate
barcode below.
Note:
You cannot enable Trioptic Code 39 and Code 39 Full ASCII simultaneously.
Code 39 Full ASCII to Full ASCII Correlation is host-dependent, and is therefore
described in the ASCII Character Set Table for the appropriate interface. See the
section --
ASCII Character Set for USB
-- or
the section --
ASCII Character Set for
Serial Hosts
.
UPC-E1
Enable/Disable UPC-E1
UPC-E1 is disabled by default.
To enable or disable UPC-E1, scan the appropriate barcode below.
Note:
UPC-E1 is not a UCC (Uniform Code Council) approved symbology.
Transmit UPC-E1 Check Digit
The check digit is the last character of the symbol used to verify the integrity of the
data. Scan the appropriate barcode below to transmit the barcode data with or
without the UPC-E1 check digit. It is always verified to guarantee the integrity of the
data.
48
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Summary of Contents for MS84X-2
Page 2: ......