- 49 -
© 2019 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS851 User’s Manual
3.5 Code 11
3.5.1 Code 11
To enable or disable Code 11, scan the appropriate bar code below.
3.5.2 Set Lengths for Code 11
The length of a code refers to the number of characters (i.e., human readable
characters), including check digit(s) the code contains. Set lengths for Code 11
to any length, one or two discrete lengths, or lengths within a specific range.
•
One Discrete Length
- Select this option to decode only Code 11
symbols containing a selected length. Select the length using the
numeric bar codes beginning on
. For example, to decode
only Code 11 symbols with 14 characters, scan
Code 11 - One
Discrete Length
, then scan
1
followed by
4
. To correct an error or to
change the selection, scan
Cancel on
.
•
Two Discrete Lengths
- Select this option to decode only Code 11
symbols containing either of two selected lengths. Select lengths
using the numeric bar codes beginning on
to decode only those Code 11 symbols containing either 2 or 14
characters, select
Code 11 - Two Discrete Lengths
, then scan
0
,
2
,
1
, and then
4
. To correct an error or to change the selection, scan
Cancel on
.
