- 30 -
© 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS851B User’s Manual
2.23 Control Character in Bar Code
Note: Partial Send only sends characters BS (0x08), TAB (0x09), CR (0x0D)
and ESC (0x1B).
Partial Send *
Don’t Send
Send
2.24 End of Batch Sending Message
Note: If ‘Send’ is selected, the scanner will send message “# End of File
Total=Number CS=0xHHHH #” before the end of batch file sending.
Number is total entries in decimal format and 0xHHHH is 32-bit
checksum in hex format.
Send
Don’t Send *
2.25 Setting Bar Codes Enable /Disable
Enable *
Disable