- 31 -
© 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS851B User’s Manual
2.26 Laser on time
This parameter sets the maximum time decode processing continues during a
scan attempt. It is programmable in 0.1 second increments from 0.50 to 9.9
seconds.
To set a Laser On Time, scan the bar code below. Next scan two numeric bar
codes beginning on
that correspond to the desired on time. Single
digit numbers must have a leading zero. For example, to set an on time of 0.5
seconds, scan the bar code below, then scan the "0" and "5" bar codes; to set
an on time of 9.5 seconds, scan the bar code below, then scan the "9" and "5"
bar codes. To change the selection or cancel an incorrect entry, scan
Cancel
on
2.27 Aim duration
It is programmable in 0.1 second increments from 0.0 to 2.0 seconds. No aim
pattern is visible when the value is 0.0.
To set an aim duration, scan the bar code below. Next scan two numeric bar
codes beginning on
that correspond to the desired aim duration.
Single digit numbers must have a leading zero. For example, to set an aim
duration of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar
codes. To change the selection or cancel an incorrect entry, scan Cancel on
