6
MS860G WiFi Manual
INTRODUCTION
Buzzer
The MS860G provides audible feedback while it is in operation.
These sounds indicate the operating status of the scanner.
One High Tone Beep
The scanner will beep once after successfully reading a bar
code.
One High-Low-High Beep
After scanning a ‘begin configuration’ bar code (“Enter Group 5”,
for instance), the scanner LED will flash green while the scanner
simultaneously gives one high-low-high tone beep. Upon exiting
configuration mode by scanning an “Exit” bar code, the scanner
will give one high tone beep, and the scanner LED will stop
flashing.
Continuous High-Low Beeps
If scans are attempted out of range, communication will be
broken. The scanner LED will remain red and you will hear a
continuous high-low beep from the scanner when you scan bar
codes. If the Access Point is powered off, this means the
communication between the scanner and the Access Point is
lost. You will also hear a continuous high-low beep from the
scanner when you scan bar codes.
