20
MS860G WiFi Manual
WiFi NETWORK SETTINGS
USING BAR CODES TO SET SCANNER NETWORK:
The WLAN default settings are shown below.
WLAN Default Settings:
Item
Default Setting
IP Address
192.168.1.250
IP Subnet Mask
255.255.255.0
Gateway IP Address
192.168.1.254
SSID
wlandemo
RF Channel
6
WEP
Disabled
Authentication Type
Auto
Use the TCP/IP barcode chart on page 62 and the ASCII Chart
on pages 65 to 68 to configure your scanner to your own
network settings, as the example below:
SSID: MySSID
IP: 192.168.1.100
Mask: 255.255.255.0
Please follow the steps below:
S c a n t h e
E n t e r G r o u p 1 0
b a r c o d e
T h e n s c a n :
S S I D S p a c e M y S S I D C R
T h e n s c a n :
I P S p a c e 1 9 2 . 1 6 8 . 1 . 1 0 0 C R
T h e n s c a n :
M A S K S p a c e 2 5 5 . 2 5 5 . 2 5 5 . 0 C R
L a s t l y , s c a n :
S E C R E E
Other than that last line, it’s pretty self-explanatory. Several
parameters can be modified together in one session, as above.
Or, only one parameter can be modified per session, as below.
The last commands -
SE
,
CR
,
EE
- are simply a sequence to
end the programming mode, and along with
Enter Group 10
must be included whenever programming network settings via
bar code.
To turn DHCP on, scan the following sequence:
Scan the
Enter Group 10
bar code
Then scan:
DHCP Space 1 CR
Lastly, scan:
SE CR EE
