MS860G WiFi Manual
25
SCANNER CONFIGURATION MANAGER
Scanner Port, continued
Codabar
N
Code 11 / Telpen
J
Code 32
T
Code 39
M
Code 93
L
Code 128
K
Delta Code
D
EAN-8
FF
EAN-13
F
I 2 of 5
I
Label Code IV or V
B
MSI
O
Plessey Code
P
S 2 of 5
H
Toshiba Code
C
UCC / EAN 128
]C1
UPC-A
A
Use Code ID
The Code ID function can be used
to identify the type of bar code
that is being scanned by inserting
an identifying letter (refer to the
chart at right) at the beginning of
the bar code input.
For example: if the Code ID
function is on, and a bar code
string of “54321” was output as
“M54321”, the bar code would
thus be identified as type Code
39.
Default is “No”.
UPC-E
E
Double Verification
Double Verification enables the MS860G to verify the accuracy
of the output by outputting only after a specified number (from 0
to 7) of identical results. For instance, if 3 is selected, the
MS860G will not output the bar code data until it’s obtained 4
identical scan results (the original scan plus 3 verifying scans).
Because the MS860G normally scans at a rate of 33 scans per
second, this process should take less than a fraction of a second,
even for higher values, for good quality bar code labels.
Default is “0-Off”.
