MS860G WiFi Manual
3
INTRODUCTION
IMPORTANT NOTES
•
"ACK” helps avoid data loss during an Access Point (AP)
power disconnection. To turn “ACK” on, follow the steps
below:
Print out pg. 65 – RS232 Settings
Scan:
Enter Group 4
C5
1
Exit
After “ACK” is turned on, the scan data transmission rate
might be a little slower, depending on your wireless network
condition.
•
If “ACK” is turned off, the scan data transmission rate will be
normal, but because the scanner’s read and transmit
functions are separate, by the time the scanner learns that
it’s become disconnected from the AP, between 5 to 8
scanned data records may not have been sent to the
network, even though the scanner gives a “good read”
signal after each of them.
•
Some APs may not be compatible with MS860G
reconnection while out of range. In this case the MS860G
will need to be powered off and on again, and also VCOM
communication will need to be restarted.
•
The VCOM Utility supports Windows 2000 and XP.
Unfortunately, Windows 98 and NT are not supported.
•
If using bar codes to configure your network settings, before
you start scanning, power off the scanner, and then scan the
“Enter Group 10” bar code on page
5
62 within 5 seconds
after turning the scanner power back on.
