-
7
-
-
8
-
GETTING CONNECTED
PINCODE SETUP
1. Press the trigger for 1 second to activate the scanner.
2. Scan [
DISCONNECT
]
3. Scan [
BT mode - SPP
]
4. Select “Wireless Scanner” from discovered device list.
If pincode is requested, enter default pincode “1234”.
5. Open serial communication software with com port
properly set up.
6. The scanner will beep twice to verify the connection.
There are two modes of wireless communication:
. E042$
BT mode - SPP
Pincode Start
. E032$
. E033$
. E043$
BT mode - HID
Disconnect
. E031$
$TX
1. Press the trigger for 1 second to activate the scanner.
2. Scan [
DISCONNECT
]
3. Scan [
BT mode - HID
]
4. Select “Wireless Scanner” from discovered device list.
5. If the Bluetooth application request to enter pincode,
please refer to
PINCODE SETUP
section on the next page.
6. The scanner will beep twice to verify the connection.
Scan numeric barcodes
(see
NUMERIC BARCODES
section
on the next pages)
based on the pincode generated
by the Bluetooth application.
STEP 1
Pincode Stop
Enter
STEP 4
STEP 3
STEP 2
[ Recommended ]
