- 80 -
MS926 User’s Manual
4.6.2 Serial Trigger Mode
You can activate the scan engine by pressing the trigger. When in serial mode,
the scan engine scans until a bar code has been read or until the deactivate
command is sent. The scan engine can also be set to turn itself off after a
specified time has elapsed.
4.6.2.1 Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scan engine’s
trigger when using serial commands to trigger the scan engine. Once the
scan engine has timed out, you can activate the scan engine either by pressing
the trigger or using a serial trigger command. After scanning the Read
Time-Out bar code, set the time-out duration (from 0-300,000 milliseconds) by
scanning digits on the
Default = 30,000 ms.
Read Time-Out
4.6.3 Presentation Mode
Presentation Mode uses ambient light to detect bar codes. The LED dims until
a bar code is presented to the scanner, then the LED brightens to read the
code. If the light level in the room is not high enough, Presentation Mode may
not work properly.
Scan the following bar code to program your scanner for
Presentation Mode.
Presentation Mode
