- 6 -
MS926 User’s Manual
1.4 Getting Started
To turn on the scanner, press and hold the
Scan & Power Button
for about 2
seconds. To turn off the scanner, press and hold the
Scan & Power Button
for
about 5 seconds.
After powering on, you will see the following screen on the scanner display.
The scanner is now under standby mode. Now you can scan the desired
barcode or start the BT pairing mode.
The standby display will show the current
Battery Status
,
Scanner Type
,
Operation Mode
, and
Time
.
The aiming beam can be
centered
over the bar code with any direction and
have the proper alignment for a good read. (see example below)
