- 25 -
MS926 User’s Manual
Chapter 3 – Symbology
3.1 All symbologies
If you want to decode all the symbologies allowable for your scanner, scan the
All Symbologies On
code. If on the other hand, you want to decode only a
particular symbology, scan
All Symbologies Off
followed by the On symbol
for that particular symbology.
Note:
Scanner performance may reduce by scanning All Symobologies On.
Only scan All Symbologies On when needed.
Note :
When All Symbologies On is scanned, 2D Postal Codes are not enabled.2D Postal
Codes must be enabled separately.
All Symbologies On
All Symbologies Off
3.2 Message Length Description
You are able to set the valid reading length of some of the bar code
symbologies. You may wish to set the same value for minimum and maximum
length to force the scanner to read fixed length bar code data.
This helps reduce the chances of a misread.
EXAMPLE: Decode only those bar codes with a count of 9-20 characters.
Min. length = 09Max. length = 20
EXAMPLE: Decode only those bar codes with a count of 15 characters.
Min. length = 15Max. length = 15
