R16 - Installation and Programming Manual
41
The dial format is determined by the detected Dial Tone. By default,
if no dial tone is detected after looping the line then the dialler will
attempt to dial regardless alternating between PULSE (Decadic) first
and then DTMF dialling.
P85E 1E: Automatic (PULSE or DTMF determined by the detected dial tone).
P85E 2E: Pulse Dialling always.
P85E 3E: DTMF Dialling always.
PROGRAMMING SEQUENCE
1. Press:
P85E
2. Press:
[1-3] E
to turn an option on.
Zone light/s on indicates which option is enabled.
PROGRAM MODE LEVEL:
Installer, Remote by PC.
FACTORY DEFAULT:
ON, Automatic Pulse or DTMF.
NOTES:
Turning ON one of the options
will turn OFF any other.
P85E
DIALLING METHOD
PROGRAMMING
This option disables the dialler even if telephone numbers and other
dialler options are programmed.
Up download or remote telephone access remain enabled.
This option is useful for temporary disabling of the dialler without
affecting other dialler options.
OFF = The dialler is enabled. (The dialler will still remain disabled if
no telephone numbers are programmed.
ON = The dialler is disabled.
PROGRAMMING SEQUENCE
1. Press:
P86E
2. Press:
1E
to turn the option on or off.
Zone light/s on indicates the option is enabled.
PROGRAM MODE LEVEL:
Installer, Remote by PC.
FACTORY DEFAULT:
OFF, Dialler is enabled.
NOTES:
The dialler can also be disabled
by deleting all telephone
numbers.
P86E, 1E
DISABLE DIALLER
The dialler normally dials only if a dial tone is detected or it can be
forced to dial without a dial tone. Allows use on PABXs with non-
standard dial tones.
OFF = Does not check for dial tone.
ON = Check for dial tone, hang up on busy tone.
PROGRAMMING SEQUENCE
1. Press:
P87E
2. Press:
2E
to turn the option on or off.
Zone light/s on indicates the option is enabled.
PROGRAM MODE LEVEL:
Installer, Remote by PC.
FACTORY DEFAULT:
ON, Check for dial tone.
NOTES:
P87E, 2E
CHECK FOR DIAL TONE
