4. Press down the battery.
5. Align two hooks at the bottom of the battery cover
with the recesses on the battery compartment and
insert, please make sure to completely cover the
battery strap.
Install the Battery (Continued)
6. Press down the battery cover, and push the battery
lock to the left to secure the battery.
Note
: Please ensure the battery
strap is not revealed.
Install the iPhone/iPad into SL220
Getting Start
Install the iPhone/iPad is with
Otterbox Case into SL220
1. Begin by removing the Sled Cover
2. Align and Slide Apple device with Otterbox
case into SL220 track:
SL220
track
Align and Slide Apple device into
SL220
Align the Apple device and slide it
into the slot on the SL220 until it
securely locks in place
Please Note:
Available for iPhones 7, 8, XR, XS 11, 12, 13, 14,
14 Plus and SE; iPad 7th, 8th, 9th, Pro 10.5-inch,
Air 3rd, Mini 5th.
Please refer to ScanBridge APK through the link:
https://www.ute.com/en/products/detail/SL220
ScanBridge App Setup
1.
Search and download
search “ScanBridge” in the App Store and
download on your device.
2
. Select Allow & Open the App:
Start Your Barcode Capturing
Remove the Battery
3. Pull the battery strap upward to remove.
1. Turn the terminal to its rear side, and push the
battery lock to the right to unlock the battery.
2. Grab two protrusions on both sides of battery
cover, and lift upward to remove it.