Chapter 2
Using the Hardware
11
Using DECT Phone (Optional)
MT180 has an optional DECT module that enables you to make intercom calls. The procedures for reg-
istering MT180 to DECT base stations may vary between phone service providers. MT180 can register
up to four base stations.
Follow instructions below to register MT180 to an AWTEK base station.
NOTE:
Before you register, make sure the voice module is properly installed while the terminal
powers on, running module checking process.
1.
Press and hold the
key on the rear panel of base station for 15~20 seconds. Then the LED
indicator on the front panel flashes.
2.
Press
F1
button to enter the terminal menu.
3.
Press
F3
button to select the
Advanced
option.
4.
Press
F5
button to enter the
Advanced
option.
5.
Enter the system login password, 12345678, by default, and then press
F5
button to confirm.
6.
Enter the
Voice
Park
option. The screen displays “Voice Module Parking OK” when registration
is completed.
Follow instructions below to make an intercom call by using an AWTEK DECT phone.
1.
Press
Talk/Doorbell
button. MT180 con-
nects to your DECT phone while the screen
displays “Connect... Please wait!”.
The LED indicator on DECT phone flashes
and the phone rings with the HS number for
MT180, HS1, by default, shown on the
screen.
2.
Press answer key
to receive the call.
MT180 beeps while the screen displays
“Calling...”. Duration of this call is shown on
the DECT phone screen.
3.
Press
À
key on your DECT phone, you can
trigger door opening.
NOTE:
Make sure the relay wiring is ready.
You can cancel registration by using a registered handset.
Follow instructions below to cancel MT180 registration on an AWTEK DECT phone handset.
1.
Press down arrow key
to enter the main menu.
2.
Press
or
key to select the
BS setting
option, and then press
key to confirm. The
screen displays “Waiting...”.
3.
Follow the on-screen prompt to input the Master PIN of base station, 0000, by default, and then
press
key to confirm. A confirmation sound beeps, and the sub menu opens.
4.
Press
or
key to select the
Remove HS
option, and then press
key to confirm. The
screen displays “Remove HS1/2/3/4/5?”.
5.
Follow the on-screen prompt to input the HS number 1/2/3/4/5 for MT180, or press
key to
cancel.
1.
Press
key to confirm. A confirmation sound beeps, and the screen displays “Not sub” when
this setting is done.
Press the button
