h.
Tighten 4 Cap Bolts per assembly for all 4 rail assemblies
IV.
PACKING CART FOR SHIPMENT
a.
Disassemble the cart using the 5/32 Allen wrench (DO NOT REMOVE THE BOLTS)…..ONLY
LOOSEN
b.
Place 3 rubber bungee cords on flat surface with hooks facing upwards
c.
Place the 4 horizontal long rails (2 with casters, 2 without) on rubber straps with the 2 without
casters in the middle and the 2 with casters on the outside (Caster plate to be facing inward)
THEN push the 4 rails together
d.
Place 2 horizontal short rails on flat surface with offsets in opposite directions and push together
e.
Take 2 vertical rails and slide under the Pin Spring (4 total) the entire length of the 2 horizontal
short rails
12
