WirelessHART Toxic & Combustible Gas Detector
IM_TCD60-01
www.ueonline.com/vanguard
15
2.6.4 Magnetic Mount
Caution: magnets may cause pinch points.
Magnet contact force is dependent on surface condition and flatness. Mount to flat, dry, clean surfaces that are
not subject to extreme environmental conditions.
This solution should not be used for overhead mounting.
1. Remove hardware from packaging (see Figure 23).
2. Attach device to mounting bracket by hooking onto top pin of mounting bracket plate (see Figure 24).
3. Push attached pin [5] through bottom holes to secure device to the bracket (see Figure 24).
4. Align magnet mount [7] to mounting location.
5. Place onto location gently or using a top-to-bottom “peeling” motion (Figure 25).
6. Use the same top-to-bottom peeling motion to remove the mount from the wall.
Figure 23
Figure 24
Figure 25
[5]
[7]
