UNITED FIRE SYSTEMS
STANDPIPE-
PAC™ MODEL SSS-101
DESIGN, INSTALLATION, OPERATION, AND MAINTENANCE MANUAL
REVISION 2.00
P/N 10-540101-001
Page 18
STEP-BY-STEP GUIDE, CONTINUED
6. See
Figure 13.4
Remove Signal Horn base-plate from back box.
7. See
Figure 13.5
Attach raceway to signal horn box at appropriate
knockout. Install raceway from factory installed Signal Horn back
box to additional Signal Horn.
NOTE
: See Table 4 for distance
limitations.
8. See
Figure 13.6
Run
14 AWG Solid
wires from additional Signal
Horn, through raceway and into factory installed Signal Horn back
box.
NOTE:
UNITED Fire Systems recommends using
RED
, and
GRAY
or
BLACK
wires for consistency and polarity identification.
9. See
Figure 13.7
Re-install Signal Horn base plate to back box on
STANDPIPE-
PAC™.
En
Figure 13.4
En
Figure 13.5
En
Figure 13.6
En
Figure 13.7
