UNITED FIRE SYSTEMS
STANDPIPE-PAC
™ MODEL SSS-101
DESIGN, INSTALLATION, OPERATION, AND MAINTENANCE MANUAL
REVISION 2.00
P/N 10-540101-001
iii
LIST OF FIGURES (continued)
11
Battery Wiring
14
12
Wiring Diagram-Notification Appliance Circuit
16
13
Signal Horn Installation Steps
17
14
Required Supervisory Pressure
21
15
Desiccant Air Dryer
39
16
Compressor Filter
40
LIST OF TABLES
Table No.
Description
Page
1
Available
STANDPIPE-
PAC™
Units
4
2
Determining Internal Volume of Standpipe
4
3
Current Requirements
–
STANDPIPE-
PAC™
Units
13
4
STANDPIPE-
PAC™
Notification Appliance Circuit (NAC) Limitations and
Other Parameters
16
5
Do’s and Don’ts
20
SAFETY INFORMATION
This manual contains safety information that is important to know and understand. This information is provided for the
safety of installers, operators, and users of the UNITED Fire Systems
STANDPIPE-
PAC™
equipment. Carefully read,
understand, and follow instructions identified by these symbols.
DANGER
The use of the word “DANGER” identifies an immediate hazard with a likelihood of death or serious personal injury
if instructions, including recommended precautions, are not followed.
WARNING
The use of the word “WARNING” identifies the presence of hazards or unsafe practices that could result in death,
personal injury, or serious property damage if instructions, including recommended precautions, are not followed.
CAUTION
The use of the word “CAUTION” identifies possible hazards or unsafe practices that could result in personal injury
or property damage if instructions, including recommended precautions, are not followed.
IMPORTANT
The use of the word “IMPORTANT” identifies special instructions, not related to hazards, that should be followed.
