GB│IE│NI
│
7
■
UAV 190 A1
Faults
If the paper jams:
This means that you have attempted to feed too much paper into the appliance
(max. 6 sheets 80 g/m
2
paper).
●
Move the switch
into the "REV" position if the paper causes a blockage.
The appliance now goes into reverse and the material that is being shredded
is ejected.
●
Pull the paper out of the appliance and then set the switch
to "AUTO".
●
The appliance is now ready for use.
If the appliance suddenly stops working:
This means that the appliance is overheated and the automatic safety cut-out has
activated itself.
WARNING – RISK OF INJURY!
►
Remove the power plug from the wall socket to avoid unintended starting of
the appliance
●
Place the switch
in the "OFF" position.
●
Allow the appliance to cool down.
●
Put the mains plug back into the socket.
●
Switch the appliance on by moving the switch
into the "AUTO" position.
If the appliance cannot be switched on:
●
Check that the plug is correctly connected to a wall socket.
●
Try a different wall socket.
●
The appliance is possibly defective. Have the appliance checked by qualified
specialists.
●
The appliance has overheated and triggered the automatic safety cut-out.
Proceed as follows:
WARNING – RISK OF INJURY!
►
Remove the power plug from the wall socket to avoid unintended starting of
the appliance
Summary of Contents for 279909
Page 3: ......
