UAV 190 B2
GB│IE
│
15
■
Operation
NOTE
►
As every shredder is tested for functionality after manufacture, it is possible
that you may find paper residue in the cutting blades .
●
Remove all packaging materials from the appliance .
●
Place the shredder on a suitable container:
place the broad end of the appliance on the edge of the container . Then pull
out the telescopic arm
6
until it sits securely on the other edge .
●
Insert the plug into a mains power socket .
Operation
You can shred up to 6 sheets (80 g /m
2
paper) at the same time .
CAUTION! MATERIAL DAMAGE!
Remove all paper clips or staples before inserting the paper into
the cutter opening
2
. The cutting blades might otherwise be
damaged .
Using auto mode
●
Set the switch
1
to the “AUTO” for shredding . The power LED
4
lights up
green . The motor starts automatically as soon you insert paper and switches
off automatically once no further paper is inserted .
NOTE
►
Always insert smaller pieces of paper into the middle of the cutter opening
2
.
This is where the contact that starts the cutting process is located .
NOTE
►
If the appliance overheats, the overheat LED
5
lights up as soon as the paper
touches the contact which starts the cutting process . The appliance will not
start cutting . Proceed as described in the section “Note regarding overheating
of the appliance” .
Summary of Contents for 307488
Page 3: ......
