UAV 190 B2
■
16
│
GB│IE
Clearing a material blockage
●
Move the switch
1
to the “REV” (“reverse”) position if the paper being
shredded causes a blockage .
The appliance now goes into reverse and the paper that is being shredded
is ejected .
●
Pull the paper out of the appliance, then set the switch
1
to “AUTO” .
●
The appliance is now ready for use .
NOTE
►
Reverse mode is solely for clearing paper jams . Do not use it for removing
documents that are already half shredded and are not causing a jam .
Switching the appliance off
●
To switch the device off, push the switch
1
to the “OFF” position .
●
If you do not intend to use the appliance for an extended period, remove the
plug from the power socket .
Note regarding overheating of the appliance
If the appliance overheats due to overloading, the overheat LED
5
lights up as
soon as a paper sheet touches the contact which starts the cutting process . The
appliance stops .
CAUTION!
►
Remove the power plug from the wall socket to avoid unintended restarting
of the appliance .
●
Empty the container .
●
Allow the appliance to cool until it has cooled to room temperature .
●
Put the mains plug back into the socket .
●
Switch the appliance on by moving the switch
1
into the “AUTO” position .
Summary of Contents for 307488
Page 3: ......
