GB│IE
│
9
■
UAV 300 A1
Turning the appliance off
NOTE
►
We recommend that you switch off the appliance and let it cool down for
about 30 minutes after 3 minutes of operation to prevent overheating.
♦
Switch the appliance off by moving the
REV/OFF/AUTO/FWD
switch
3
to
the
OFF
position. The
power
lamp
4
goes out.
Overheating protection
This appliance is fitted with overheating protection. If the motor overheats due to
overloading, the appliance switches itself off automatically. The
overheat
lamp
5
lights up permanently red until the motor has cooled down sufficiently.
If this occurs, do the following:
WARNING! – RISK OF INJURY!
►
Pull the power plug
1
out of the power socket to prevent unintended
starting of the appliance.
♦
Switch the appliance off by moving the
REV/OFF/AUTO/FWD
switch
3
to
the middle
OFF
position.
♦
Empty the waste collectors
0
/
w
.
♦
Allow the appliance to cool down for about 30 minutes.
♦
Replace the plug
1
in the mains power socket.
♦
Switch the appliance on by moving the
REV/OFF/AUTO/FWD
switch
3
to the
AUTO
position. The
overheat
lamp
5
no longer lights up once the
appliance has cooled down sufficiently.
Emptying the waste collectors
WARNING! RISK OF INJURY!
►
Remove the power plug
1
from the power socket to prevent the appliance
from accidentally switching on.
NOTE
►
Empty the waste collectors
0
/
w
regularly to prevent the shredded
material from being drawn into the cutting blades from below.
►
Dispose of the waste material in an environmentally-responsible manner.
♦
Hold the cutter attachment
6
by the two integrated carrying recesses
8
on the left and right and pull it off the large waste collector
w
.
♦
Pull the small waste collector
0
out of the large waste collector
w
.
♦
Empty the large waste collector
w
and small waste collector
0
separately.
