UAV 190 C2
GB│IE
│
9
■
Faults
If the paper jams:
This means that you have attempted to feed too much paper into the appliance
(max. 6 sheets 80 g /m
2
paper).
♦
Move the switch
1
into the
REV
position if the paper causes a blockage.
The appliance now goes into reverse and the material that is being shredded
is ejected.
♦
Pull the paper out of the appliance and then set the switch
1
to
AUTO
.
♦
The appliance is now ready for use.
If the appliance suddenly stops working:
This means that the appliance is overheated and the automatic safety cut-out has
activated itself. The overheat LED
4
lights up red.
WARNING!
►
Remove the power plug from the wall socket to avoid unintended restarting
of the appliance.
♦
Place the switch
1
in the
OFF
position.
♦
Empty the container.
♦
Allow the appliance to cool until it has cooled to room temperature.
♦
Put the mains plug back into the socket.
♦
Switch the appliance on by moving the switch
1
into the
AUTO
position.
If the appliance cannot be switched on:
♦
Check that the plug is correctly connected to a wall socket.
♦
Try a different wall socket.
♦
The appliance is possibly defective. Have the appliance checked by qualified
specialists.
♦
Check whether the overheat LED
4
has come on. If it has come on, the
overheating protection has been triggered. Proceed as described in the sec-
tion
Note regarding overheating of the appliance
.
Summary of Contents for UAV 190 C2
