ULG 350 B1
GB│IE│NI
│
9
■
Preparing for cold lamination
IMPORTANT
►
After hot laminating, allow the laminator to cool down completely before
beginning with cold lamination. Bear in mind, the rollers inside the laminator
will still be hot. This could damage the laminating pouch and the document
to be laminated!
♦
Insert the plug of the laminator into a mains power socket.
♦
Switch the appliance on by pushing the On/Off switch
5
to the “ON” position.
The red Power indicator light
2
lights up.
♦
Set the selector switch for hot and cold lamination
6
to “COLD”. The green
Ready indicator light
3
lights up.
♦
Place the pouch thickness switch
4
at the corresponding pouch thickness
(see also chapter
Switching levels
).
♦
Place the document to be laminated into a laminating pouch of the appropriate
size.
NOTICE
►
Ensure that all edges of the document have at least two millimetres of space
to the edges of the laminating pouch, as shown in Fig. 1.
►
Make certain that you use only one pouch for laminating. First flip it up, as
shown in Fig. 2.
►
For further information about the lamination process, please read the section
Lamination process
.
Lamination process
♦
Place the pouch centrally on the small supporting surface at the pouch slot
.
If the size permits, the pouch should be placed with the closed side towards
the pouch slot
.
♦
Slide the pouch slowly and straightly into the pouch slot
.
♦
When you have slid the pouch several centimetres into the slot
it will then
be pulled in automatically. Release the laminating pouch as soon as you
notice it being pulled in automatically.
IMPORTANT
►
Ensure there is at least 30 cm of open space in front of the laminator. Oth-
erwise, the pouch will not be ejected completely from the laminator after
lamination. This could damage the pouch.
♦
The finished and laminated pouch is ejected from the pouch ejector slot
of the laminator.
Summary of Contents for ULG 350 B1
Page 3: ......
