© United Products 2017
Designed in Australia
01
02
03
04
05
06
Installation Manual
Ledge Basin 1 012 001
Installation Instructions - if you have any doubts please contact us: hello@united-products.co
01. Position basin. Standard height 900mm from finished floor. Verify integrity of vanity surface and plumbing is in
appropriate position for basin installation.
02. Use saw and cut ø160mm waste/installation hole in level vanity surface. Hole center recommended minimum
220mm from finished wall.
03. Install waste specified for the basin.
04. Invert basin, confirm surfaces are clean and dry. Apply anti-fungal silicone adhesive to basin. Place basin in
position aligning waste ensure basin is level.
05. Allow silicone to cure ensure basin is level. Affix basin mounting clips. Connect basin to waste,
bottle or s trap can be used.
06. Clean with a soapy sponge, followed by a rinse. For stubborn stains such as lime scale or soap build up
use a mild abrasive cleaner like gumption®paste, jif® cream or ajax® cream or powder - use with a soft damp cloth
in wide circular motions. Enjoy
900mm
220mm
