© 2022 United States Stove Company
11
INSTALLATION
VENTING YOUR PELLET STOVE INTO AN
EXISTING CLASS A 6” CHIMNEY SYSTEM
1.
IMPORTANT:
If you are installing your pellet stove as a
replacement to an existing wood stove, you
can install your pellet stove using the existing
class A 6” venting system.
You must have the existing chimney system
cleaned and/ or inspected by a qualified
chimney sweep before proceeding with the
installation of your pellet stove.
2. To the right is an example of an installation
using part number 860001, 3-6” transition into
6” connector pipe. the illustration is only an
example. Please conform to any local building
codes or regulations having jurisdiction before
you have a qualified installer proceed with this
installation.
Existing Class ‘A’
6” Chimney System
3” PL Vent
Clean Out Tee
Support
Bracket
Ceiling
Support
3” to 6” Pipe
Adapter
Summary of Contents for KP5522
