14
USSC
Your
American Harvest Corn/Pellet Stove
comes to you with the glass door installed in place, ready for use. The
glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (4) clips.
REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS
Open the door and lift off of hinges. If the door is tight, tap gently on the bottom of the door with your hand or rubber
hammer. Lay door down on newspaper with glass clips facing you. Using a #2 Phillips screwdriver, loosen the screws
and take off the glass clips. Remove the broken glass carefully and discard.
Reverse the above procedure for replacing new glass with new gasket.
WARNING
Do not operate unit with broken glass.
Do not substitute original factory glass.
You must use only factory authorized glass;
Do not slam door shut.
Do not strike glass.
Do not use abrasive cleaners.
Do not clean when glass is hot.
CLEANING THE GLASS
When the fire is first started, it will produce some smoke. The smoke might accumulate on the glass surface. Before the
fire gets hot, open the door and wipe the glass surface off with a damp rag. Do not touch the surface with your hands.
If after constant use, the glass is dirty, you must clean the glass so that it will not become etched with the fly ash. When
the glass has cooled off, take a damp rag, put a little fly ash from the unit on it and clean the glass. If this does not clean
the glass use a non-abrasive spray; 409 works well.
GLASS MAINTENANCE, REMOVAL AND REPLACEMENT
GLASS CLIPS
Summary of Contents for American Harvest 6035
Page 25: ...USSC 25 WIRING DIAGRAM...
