-8-
Accessory Installation
THERMODISC
THERMODISC
COVER
4” ELECTRICAL
JUNCTION BOX
BLOWER
BLOWER GASKET CLIP NUTS
(Not used in the upper center hole)
ASSEMBLY OF FURNACE
Your furnace requires the following items to be assembled or installed
by the service person:
Blower and Blower Control
Electrical Connections
1.
Remove all parts from the unit (blower, thermodisc, and all
wiring) and inspect for damage, including the firebrick as some
breakage could occur during shipment.
2.
Install the thermodisc on rear of furnace cabinet with the two
screws provided. Mount the conduit assembly from the junction
box to the thermostat bracket. Crimp the two female terminals
to each of the wire leads. Plug the wires to the thermodisc. NOTE:
It does not matter which of the two wires plugs to which terminal
on the thermodisc.
3.
Remove blower from cartons. Remove junction box cover.
Attach clip nuts as in figure shown. Install blower(s) and gasket(s
with 1/4"-20 x 3/4" bolts as shown.
4. Refer to the wiring diagram for instructions on how to properly
wire the components.
SMOKE CURTAIN
Using two 1/4-20 x 1-1/4”
Carriage bolts, two smoke
curtain clips, and two nuts,
attach the smoke curtain
in place above the fuel
feed door as shown. After
installation, the smoke curtain
should swing freely back into
the furnace.
DOOR LATCH INSTALLATION
Use the two included bolts and nuts to secure the handle to the stove as shown.
Note: Adjust the handle as needed to insure a proper seal.
