![background image](http://html1.mh-extra.com/html/united-states-stove/ashley-ag30fp/ashley-ag30fp_manual_4498711022.webp)
-22-
Log And Liner Installation
• If converting to LP (propane) gas, complete the conversion before installing the log set. Follow the conversion
instructions included with the kit.
• Refer to the instruction sheets provided with your log and liner set for proper installation.
Only log and liner sets certified with the appliance shall be used. NOTE: This appliance should not be burned
without the approved logs and/or liners properly installed. Use without the logs and/or liners properly installed
could cause damage to the appliance.
WARNING: Do not place logs directly over burner port holes. Improper log placement may affect flame
appearance and cause excessive soot to build upon the logs and glass.
Certified Log Set
892915 - Riverside
892916 - Timber Ridge
Certified Liner Set
892917 - Aged Red
892918 - Black Tie
892919 - Baker Street
892930 - Frisco Ledgestone
Setup
GLASS FRAME ASSEMBLY
REMOVE GLASS FRAME ASSEMBLY
1. Locate (2) spring-loaded latches securing the glass assembly at
the bottom of the firebox.
WARNING: Use only authorized parts and materials when replacing defective or damaged glass.
WARNING: Do not remove the glass assembly when hot.
WARNING: Do not operate with the glass removed, cracked, or broken. Replacement of the glass assembly,
should be done by a licensed or qualified service person.
2. Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
3.
Lift the glass assembly up and off of the (2) tabs located at the top of the firebox.