United States Stove Clayton CL1660E, Owner'S Installation And Operation Manual

3

Combustible:

Wood

Flue Pipe Diameter:

6” (153cm)

Flue Pipe Type: (Standard Single Wall or Double Wall):

Black or Blued Steel 2100°F (650°C) Class “A”

Minimum Chimney Height:

12’

Maximum Log Length:

28”

Electrical:

120V, 60Hz, 3.4A per blower

Dimensions

Combustion Chamber:

Width x Depth:

17.4” X 28.3”

Volume:

Cubic Feet:

6.27 cubic ceet

Door Opening: Width x Height:

12.625” X 12.5”

Weight (lbs):

509lbs

Specifications

CONGRATULATIONS!

You’ve purchased a heater from North America’s oldest manufacturer of wood burning products.

By heating with wood you’re helping to CONSERVE ENERGY!

Wood is our only Renewable Energy Resource. Please do your part to preserve our wood supply. Plant at least 

one tree each year. Future generations will thank you. 

This manual describes the installation and operation of the Clayton, CL1660E 

wood heater. This heater meets the 2016 U.S. Environmental Protection Agency’s 

emission limits for wood heaters sold after May 15, 2016. Under specific EPA 

test conditions this heater has been shown to deliver heat at a rate of 33,438 

to  77,456  BTU/hr.  This  heater  achieved  a  particulate  emissions  rate  of  0.305 

lbs/mmBTU when tested to method CSA B415.1-10 (*and an overall efficiency 

of 61.9%.) The maximum overall heat output of this heater was tested to be 

104,720 BTU/hr.

This wood heater has a manufacturer-set minimum low burn rate that must not be altered. It is against federal 

regulations to alter this setting or otherwise operate this wood heater in a manner inconsistent with operating 

instructions in this manual.

The operation of this wood heater in a manner inconsistent with the owner’s manual will void your warranty and 

is also against federal regulations.

This heater is designed to burn natural wood only. Higher efficiencies and lower emissions generally result when 

burning air dried seasoned hardwoods, as compared to softwoods or to green or freshly cut hardwoods.

This wood heater needs periodic inspection and repair for proper operation. It is against federal regulations to 

operate this wood heater in a manner inconsistent with operating instructions in this manual.

0215WH080E