-3-
Refer to diagram and parts lists at back of this manual
1. Check the Owner’s Manual for your stove and do
not reduce any minimum clearances which may
be listed there. Use only Type A (all-fuel) or lined
masonry chimneys to connect to your stove. Check
your local and state building codes for proper and
safe installation.
2. If you have determined your chimney to have
an inadequate draft, overcome that deficiency
before installing your appliance. Your chimney
should be capable of developing at least 0.06 w.c.
(measured in water column) draft before installing a
Miracle Heat. After installation, the chimney should
develop at least 0.045 w.c. as measured below
the Miracle Heat All stove pipe above or below
your Miracle Heat must be 24-gauge or heavier
to provide adequate support. Any horizontal run
of pipe must pitch upward toward the chimney at
least 1/4” per foot of horizontal run. All stove pipe
and/or elbow joints must be secured by at least
three (3) sheet-metal screws.
3. Any elbow installed below your Miracle Heat should
be of the non-adjustable type.
4.
If your stove requires a hand damper (wood and
coal stoves), install BELOW the Miracle Heat.
5. Note: The power cord must not contact any part
of the stove, chimney connector(s) or the Miracle
Heat components. Secure the power cord to keep
it away from hot surfaces or their proximity.
6.
The Miracle Heat pipe size must be the same or
larger diameter than the flue outlet of the heating
appliance.
7. All electric supply cord connections shall comply
with the requirements of local authorities having
jurisdiction over such matters.
8.
Overfiring this unit is not recommended. Refer to
your heating appliance owner’s manual regarding
overfiring.
9.
The Miracle Heat must be installed in your flue pipe
vertically. It may be installed with the crimped end
either up or down, according to your installation
needs.
10. The Miracle Heat should be installed as close to the
flue outlet as possible, but no closer than 15” from
the top or back as shown in figure 2.
11.
Do Not install the Miracle Heat closer than 18” from
any combustible material.
12. Use at least three (3) sheet metal screws at each
connection to secure the Miracle Heat to the flue
pipe.
13.
Keep the power cord at least 12” away from the
flue pipe.
NOTICE: In case of a power outage, your stove may
be kept in use with low heat fires provided you remove
the rear panel of the Miracle Heat (fan and electrical
components).
Installation Instructions
