-14-
CHIMNEY DRAFT
NOTE: A DRAFT READING OF 0.05[12.45] to 0.06[14.94]
(Water Column[Pascals]) IS REQUIRED FOR PROPER
BURNING OF THIS APPLIANCE.
Draft is a function of the chimney, NOT THE APPLIANCE
— Do not expect the appliance to draw. Smoke spillage
into the house or excess buildup of condensation or
creosote in the chimney are warnings that the chimney
is NOT functioning properly. Correct the problem before
using the appliance. Following are some possible causes
for improper draft.
1.
The connector pipe may be pushed into the chimney too far, stopping the draft.
2.
If the chimney is operating too cool, water will condense in the chimney and run back into the appliance.
Creosote formation will be rapid and may block the chimney. Operate the appliance at a fire level high
enough to keep the chimney warm preventing this condensation.
3.
If the fire burns well but sometimes creates excessive smoke or burns slowly, it may be caused by the chimney
top being lower than another part of the house or a nearby tree. The wind blowing over a house or tree falls on
top of the chimney like water over a dam, beating down the smoke. The top of the chimney should be at least
three (3) feet above the roof and be at least two (2) feet higher than any point of the roof within ten (10) feet.
ASH REMOVAL AND DISPOSAL
Whenever ashes get 3 to 4 inches deep in your firebox or ash pan, and when the fire has burned down and cooled,
remove excess ashes. Leave an ash bed approximately 1 inch deep on the firebox bottom to help maintain a hot
charcoal bed. Ashes should be placed in a metal container with a tight-fitting lid. The closed container of ashes
should be placed on a noncombustible floor or on the ground, away from all combustible materials, pending
final disposal. The ashes should be retained in the closed container until all cinders have thoroughly cooled.
SMOKE AND CO MONITORS
Burning wood naturally produces smoke and carbon monoxide(CO) emissions. CO is a poisonous gas when
exposed to elevated concentrations for extended periods of time. While the modern combustion systems in
heaters drastically reduce the amount of CO emitted out the chimney, exposure to the gases in closed or confined
areas can be dangerous. Make sure your stove gaskets and chimney joints are in good working order and sealing
properly to ensure unintended exposure. It is recommended that you use both smoke and CO monitors in areas
having the potential to generate CO.
GLASS CARE
The following usage and safety tips should be observed:
1.
Inspect the glass regularly for cracks and breaks. If you detect a crack or break, extinguish the fire immediately
and contact the manufacturer for a replacement.
2.
Do not slam the door or otherwise impact the glass. When closing doors, make sure that logs or other objects
do not protrude to impact the glass.
3.
Do not build fires against (or that might fall against) the glass.
4.
Do not clean the glass with materials that may scratch (or otherwise damage) the glass. Scratches on the
glass can develop into cracks or breaks during operation.
5.
Never attempt to clean the glass while the unit is hot. If deposits are not very heavy, normal glass cleaners are
adequate using a soft, non-abrasive cleaning pad. Heavier deposits may be removed with oven cleaners.
6.
Never put substances which can ignite explosively in the unit. Even small explosions in confined areas can
blow out the glass.
GLASS REPLACEMENT
1. Ensure appliance is not in operation and is thoroughly cooled.
2.
Remove screw and glass clip. (See parts list and diagram.)
3.
Lift glass out from glass clip.
4.
Remove old gasket and clean glass.
Summary of Contents for US1800E
Page 19: ...19 Notes...
