18
LenelS2 EVA 54 User Manual
These attach at the front sides of the device housing. Once the brackets are securely
attached (see right ear bracket below) and the unit has been properly installed in the
sliding rail system, these handles can be used to pull or push the device out or into
the rack system, while the sliding rails support the weight of the device.
Install the sliding rails and place device in rack
Follow the procedure below to install the sliding rails in the rack system, then place
the LenelS2 EVA 54 into the rails and secure the device to the rack.
1. Determine what height to place the enclosure in the rack, then place the right and
left rack rails at the same height in the right and left rack position (see graphic
below).
Note:
Three holes are required on each front post, the uppermost of the three to
be used for the flange nuts to anchor the enclosure to the rack posts. Adjust the
length of the mounting rails as needed.
Note:
Each end of the sliding rails has a lever to operate the lock mechanism that
grips the rack post.
2. Secure the rails to the rack posts. Make sure the rack rails are properly oriented
in the rack. Press the lever to release the lock.