Page
15
of
54
4.3
Physical buttons
The headset is operated using the buttons on the earcup with boom arm. The ANC button is located on
the opposite earcup, as ANC is not available for Mono headsets
(Fig.8)
The following table represents the functions of the buttons seen on the figures above
INPUT
FUNCTIONS
POWER SLIDER
Power the headset on and off
SCROLL WHEEL WITH AN INTEGRATED KEY
Increase volume
Decrease volume
MULTI-FUNCTION BUTTON
Answer call
End call
Reject call
Trigger AI voice assistant
Microsoft Teams button
Hold/Swap/Retrieve Call
Leave conference during call
MUTE KEY
Toggle mute
Play/Pause music
Skip to next track (double click)
Announce battery level (press and hold)
DECT KEY
Enter DECT pairing mode
Toggle between Base and Dongle (On-the-Go kit)
Reset settings (press and hold)
De-register 2
nd
headset during Idle
BT KEY
Toggle Bluetooth
™
Enter Bluetooth
™
pairing mode
ANC KEY
Toggle ANC
For more details on the Clave headset controls refer to 8.1. Controls.
4.4
LED overview
The headset has a single tricolor LED on the tip of the boom-arm, which is a combination of 3 LEDs
–
red,
green,
and blue. All visual indications are disabled if “eco mode” is enabled.
4.4.1
LED patterns
The LED supports 3 different kinds of patterns. The definitions of each pattern can be seen in the table
below:
LED PATTERN
DEFINITION
BLINK
ON-OFF
BREATHING
One color that slowly becomes brighter until it reaches full brightness
and then dimmers until fully dimmed. It is a repeated cycle.
ALTERNATING
Alternating between two colors
