Page
21
of
54
6.2
Dual functionality
The Clave DECT is a dual-mode device in a shared hardware. This means that the user can switch
between the functionalities by using the slider switch. Firmware updates and configuration are managed
via the PC Setup tool. The table below presents the differences between the 2 modes.
DIFFERENT MODES
FUNCTIONALITY
Base Station (Fixed Part)
Acts as DECT base for the Clave Headsets;
Slider is placed at the bottom (towards the USB connector);
It is possible to verify the current setting of the Clave DECT Dongle in
the PC Tool;
Headset (Portable Part)
Enables DECT access for a USB desktop phone on the UH VoIP System;
Slider is placed at the top;
It is possible to verify the current setting of the Clave DECT Dongle in
the PC Tool;
6.3
LED Patterns
The LED support different kinds of patterns, such as fast blink, slow blink, normal blink and breathing:
LED PATTERN
DEFINITION
BLINK
ON/OFF
BREATHING
OFF-ON-OFF slowly
6.4
LED Indication
The following table shows the LED indication for different status of the DECT dongle.
FUNCTION
STATUS
LED
PATTERN
SYSTEM
Dongle reset started
Red, Blue and Green Blink 3 times
DECT
CONNECTION
Registration, In progress
Blue
Blink alternately
Registration, Success
Blue and Green
Blink 3 times
Registration, Failed
Blue and Red
Blink 3 times
Master headset registered
Blue
ON
Master headset lost link
Red
ON
Ringing
Green
Blink
CALL
Talk or Hold
Green
ON
Conference or intrusion call Green
Breathing
